LPS Mini Adaptor

20.00 (excl VAT)

64 in stock

Category:

Description

Adaptor for LPS Mini for very easy access to all I/O, UART, ISP and power pins. Acts as a bridge between TE Connectivity 5650712-1 (holds LPS Mini) and the standard Arduino Nano footprint.

In most cases this adaptor is of no use except during test and debug. If all I/O is needed on a permanent basis, LPS might be a better choice than LPS Mini.

The adaptor is shipped with one angled 1×6 pin header (UART), one straight 2×3 pin header (ISP), two straight 1×30 pin headers (I/O) and one TE Connectivity 5650712-1 (edge connector). Only the edge connector is soldered in. The rest is up to the user to solder in if needed.

The UART connector mates with FTDI USB TTL Serial Cable TTL-232R-3V3 (not included).

The ISP connector mates with the standard AVR ISP 6-pin header. LPS Mini is shipped with a boot loader accessible via the UART connector, so the ISP connector is most likely never to be used.

If using the power pins: cables are to be preferred. Pin headers will get too close to the antenna.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.